Operation CHARM: Car repair manuals for everyone.

Fuel Return Line: Service and Repair




^ Push the ends of the fuel hoses onto the respective fittings.

Specification: More than 25 mm (0.99 in)

^ Install the clip on the fuel hoses.

Specification:
2-5 mm (0.08-0.2 in) from the end of hose


Steps after installation
1. Connect data link connector terminals F/P and GND with a jumper wire.
2. Turn the ignition switch to ON and check for fuel leaks from the fuel distributor assembly.
3. Turn off the ignition switch and disconnect the jumper wire.
4. If leaks are found, reinstall the fuel injector.