Expansion Valve: Service and Repair
Disassembly / Assembly
1. Disassemble in the order shown in the figure.
2. Assemble in the reverse order of disassembly.
1. Tapping screw
2. Power transistor
3. Polyurethane foam
4. Polyurethane protector (pipe)
5. Polyurethane protector (blower side)
6. Polyurethane protector (heater side)
7. Tapping screw
8. Bracket
9. Hex tapping screw
10. MAX-HI relay
11. Aspirator
12. Tapping screw
13. Cooler case (top)
14. Cooler case (bottom)
15. Harness clip
16. Sensor clamp
17. Evaporator temperature sensor
18. Adhesive sponge rubber
19. Clamp
20. Insulator
21. Expansion valve
22. O-ring (high side)
23. O-ring (low side)
24. Evaporator
Assembly note
Expansion valve
1. Replace the O-rings at the expansion valve joints.
2. Apply compressor oil to the O-rings and connect the joints.
3. Tighten the joint to the specified torque by using two open-end wrenches.
4. Assemble the heat-sensing tube as shown in the figure.
Evaporator temperature sensor
Assemble the evaporator temperature sensor as shown in the figure.