Refrigerant Pressure Check
Checking Refrigerant Pressure1. Move the vehicle to a place that is not directly exposed to the sun.
2. Install the manifold gauge set.
3. Close the hood temporarily.
4. Close all doors and all windows.
5. Start and warm up the engine and then run it at a constant 1,500 rpm.
6. Press the AUTO switch on.
7. Set the temperature to 18°C {65°F} by the temperature setting dial.
8. Wait until the passenger compartment temperature stabilizes.
9. After the passenger compartment temperature stabilizes, read the high-and low-pressure-side readings of manifold gauge and ambient temperature.
10. Verify that the high-and low-pressure-side readings of manifold gauge are within the shaded zones shown in the figure.
- If the pressures are not as specified, refer to the following table and repair the system.
- If the pressures are normal, inspect the control system.