Replacement

VEHICLE SPEEDOMETER SENSOR
Replacement
1. Disconnect the negative battery cable.
2. Remove the front exhaust pipe. (left side)
3. Disconnect the vehicle speedometer sensor connector.
4. Remove the vehicle speedometer sensor from the extension housing.
5. Apply ATF to a new O-ring and install it on the vehicle speedometer sensor.
6. Install the new vehicle speedometer sensor.

Tightening torque: 5.0 - 6.8 N.m {50 - 70 kgf.cm, 44 - 60 in.lbf}

7. Connect the vehicle speedometer sensor connector.
8. Install the front exhaust pipe.
9. Connect the negative battery cable.