Operation CHARM: Car repair manuals for everyone.

Replacement

PARK-NEUTRAL SWITCH
Replacement




1. Remove the selector rod from the manual shaft lever.
2. Move the manual shaft to N range position.
3. Loosen the park/neutral switch mounting bolts.





4. Align the holes of the park/neutral switch and the manual shaft lever by inserting an approx. 4.0 mm {0.157 in} outer diameter pin.
5. Tighten the park/neutral switch mounting bolts and remove the pin.

Tightening torque: 2.5 - 3.9 N.m {25 - 40 kgf.cm, 22 - 34 in.lbf}

6. Recheck the continuity of the park/neutral switch.
7. If not correct, replace the park/neutral switch.
8. Install the selector rod to the manual shaft lever.