Operation CHARM: Car repair manuals for everyone.

Idle Speed: Adjustments


Adjustment / Preparation
1. Warm up the engine to normal operating temperature.
2. Turn all electric loads OFF.
3. Connect the Special Service Tool (SST) to the data link connector.




4. Connect a tachometer to the data link connector, Ignition (IG) terminal as shown.
5. Set switch A to position 1.




6. Set TEST Switch (SW) to SELF-TEST.
7. If the SST is not used, jump across the TEN Terminal and the Ground (GND) Terminal of the data link connector.




Idle Speed
1. Perform "Adjustment/Preparation" steps 1 - 7.
2. Check that the idle speed is within specification.

Idle speed (P range): 680-72O RPM

3. If not within the specification, adjust the idle by turning the air adjusting screw.
4. Disconnect the SST.