Cold Start Injector: Testing and Inspection
COLD-START INJECTOR
Inspection (On-vehicle)
1. Disconnect the cold-start injector connector.
2. Measure resistance of the injector with an ohmmeter.
Resistance: 2.7-3.4 ohms at 20°C (68°F)
3. Replace the cold-start injector if necessary.
Inspection / Fuel Leakage Test
WARNING: Fuel line spills and leaks can be dangerous. Fuel can ignite and cause serious injuries or death and can damage the vehicle. Fuel can also irritate skin and eyes. To prevent this from happening, release the fuel pressure according to "Fuel Line Safety Procedures".
Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel.
1. Disconnect the cold-start injector connector.
2. Remove the cold-start injector with the fuel pipe connected.
3. Wrap the cold-start injector with a plastic bag.
4. Connect the data link connector terminals F/P and GND by using a juniper wire.
5. Turn the ignition switch ON.
6. Verify that no fuel leaks from the injector nozzle.
7. If there is more than one drop per minute from the injector nozzle, replace the injector.
8. Turn the ignition switch to OFF and remove the jumper wire.
Volume Test
WARNING: Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel.
1. Remove the cold-start injector with the fuel pipe connected.
2. Connect the Special Service Tool (SST) as shown in the figure.
3. Connect the data link connector terminals F/P and GND by using a jumper wire.
4. Turn the ignition switch ON.
5. Set the select switch 1
6. Push the injection switch ON for 15 seconds.
7. Measure the injection volume by using a graduated container.
Injection Volume: Approx. 25.9-31.6 ml (0.78-0.94 fl.oz.)/15 sec.
8. If not within specification, replace the injector.