Operation CHARM: Car repair manuals for everyone.

Step 3




DISASSEMBLY-STEP 3
Disassemble in the numbered order shown in the image.




Shift Fork Assembly
Disassemble the 1st - 2nd shift fork, interlock sleeve, and 3rd - 4th shift fork after setting them as shown in the image. Slide the 3rd - 4th shift fork and interlock sleeve off the shaft.




Bearing Inner Race (1st gear end of primary shaft gear)
Press the bearing inner race from the shaft with the SST.

CAUTION: Hold the shaft with one hand so that it does not fall.




Bearing Inner Race (4th gear end of primary shaft gear)
Press the bearing inner race from the shaft with the SST.

CAUTION: Hold the shaft with one hand so that it does not fall.




Bearing Inner Race and 4th Gear (Secondary shaft gear assembly)
Remove the bearing inner race and the 4th gear with the SST. Position the puller between the two sets of gear teeth on the 4th gear.

CAUTION: Hold the shaft with one hand so that it does not fall.




Clutch Hub Assembly (3rd - 4th gear)
Set the SST onto the 3rd gear between the two sets of teeth, and then, by using a press, remove the clutch hub assembly together with the gear.

CAUTION: Hold the shaft with one hand so that it does not fall.




Clutch Hub Assembly (1st - 2nd gear)
Support the 1st gear and press it and the clutch hub assembly off the secondary shaft.

CAUTION: Hold the shalt with one hand so that it does not fall.







Bearing Inner Race (Drive pinion end of secondary shaft gear)
Remove the bearing inner race from the shaft with the SST.

CAUTION: Hold the shaft with one hand so that it does not fall.