Operation CHARM: Car repair manuals for everyone.

Evaporative Check Valve: Testing and Inspection

Fig. 45 Removing Check And Cut Valve.:





1. Remove the check and cut valve Fig. 45.

Fig. 46 Testing Check And Cut Valve.:





NOTE: This test should be performed with the valve located horizontally, otherwise the weight of the valve will cause it to move out of position and close the passages.

2. Connect a pressure gauge to the passage from the fuel tank.
3. Blow through the valve from (A) Fig. 46. The valve should open with a pressure of 0.14-0.71 psi (0.98-4.9 kPa , 0.01-0.05 k/cm squared).
4. Remove the pressure gauge and connect it to the passage to atmosphere.
5. Blow through the valve from (B) and if the valve opens at a pressure of 0.78-1.00 psi (5.39-6.87 kPa , 0.055-0.07 k/cm squared), the valve is normal.