Camber Adjustment-Rear
1. Note: Only camber and toe are adjustable on the rear suspension system.Note: When both the camber and toe are out of adjustment, adjust the camber first.
Measure the camber.
^ Use an alignment rack meeting the following specifications.
^ All wheel alignment measurements must be performed on an alignment rack leveled to within 1.59 mm (1/16 inch) side-to-side and front-to-rear and calibrated to within + 0.1° camber and + 0.3° toe.
^ The instrumentation must be able to compensate for wheel runout and must be able to read individual (LH and RH) toe measurements.
2. Loosen both lower rear suspension arm pivot bolts and nuts. Rotate both alignment cams to the neutral position (notches pointed down).
3. Rotate both alignment cams equally in the same direction until the required setting is obtained.
4. Tighten the nuts.
5. Recheck the camber.