Disc Brake System: Testing and Inspection
CAUTION:- The rotor runout specification must be met to ensure proper brake performance without roughness complaints.
- Do not install disc brake rotors that are less than the minimum thickness specified. Do not machine a disc brake rotor below the minimum thickness specification.
NOTE:
- When installing disc brake rotors, always align the painted match marks on the disc brake rotors with those on the front hub or rear axle.
- When installing disc brake rotors, always apply High Temperature Nickel Anti-Seize Lubricant F6AZ-9L494-AA or equivalent meeting Ford specification ESE-M12A4-A to the rotor-to-front hub or to the rotor-to-rear axle mating surfaces.
1. Do not remove the tire and wheel assembly. Tighten the lug nuts to specification.
2. Raise and support the vehicle.
3. Assemble the tire and wheel runout gauge set, using the spherical tip extension.
4. Locate an opening on the inboard side of the dust shield that will allow the dial indicator tip to be positioned at least 5 mm (0.2 inch) from the outer edge of the disc brake rotor.
5. Clamp the tire and wheel runout gauge set on the vehicle, making sure the flexible indicator arm and probe tip do not touch the dust shield or tire while rotating.
NOTE: Do not clamp the gauge set to a vehicle component separated from the disc brake rotor by a flexible joint, such as a ball joint or body mount.
6. Rotate the wheel for six revolutions, and record the total indicated runout.
NOTE: For rear wheel measurement only, have an assistant push in on the wheel cover or axle shaft center while rotating the wheel.
7. If the total indicated runout exceeds the maximum specification, remove the disc brake rotor.
8. Clean the rotor mounting face of dirt, rust and debris.
9. For front wheels, measure and record the total indicated runout of the hub face outside the stud circle.
10. Replace the front hub if the total indicated runout exceeds the maximum specification.
- Repeat the hub runout measurement.
11. For rear wheels, measure and record the total indicated runout at a point on the axle shaft outside the stud circle.
NOTE:
- Clean the axle flange surface before measuring.
- For rear wheels, press inward on the axle shaft while measuring the rear axle runout.
12. If the total indicated runout exceeds the maximum specification, inspect the rear axle. Repair as necessary.
- Repeat the rear rotor runout measurement.
13. If the rotor TIR is still out of specification, measure and record the thickness of the disc brake rotor. If thickness is sufficient to machine the disc brake rotor to the runout specification, go to Step 14. If the thickness is not sufficient, replace the disc brake rotor and recheck the TIR.
14. Machine the disc brake rotor if final thickness will not be less than the maximum specification. Recheck the rotor runout.
NOTE: Rotor machining must be done with an on-line lathe. Follow the lathe manufacturer's instructions.