J1850 Communication Network
The J1850 communication network provides:
^ the ability for module-to-module communication by sharing required inputs and outputs instead of each component having an input or output wired directly to or from each affected module.
^ a common link for communication to an off-board tester through the data link connector (DLC) located under the instrument panel to the right of the steering column.
Two micro-processor based subsystems are included on this network:
^ powertrain control
^ climate control
The J1850 communication bus between these subsystems and the data link connector consist of an unshielded twisted pair of wires:
^ Circuit 914 (T/O) J1850 bus(+).
^ Circuit 915 (PK/LB) J1850 bus(-).
Fault Tolerance
The J1850 communication network will remain operational in the event:
^ one circuit is severed.
^ one circuit is shorted to ground.
^ one circuit is shorted to battery positive (B+) voltage.
^ a termination resistor is lost within a module.
^ one or more modules fail internally.
Any of these conditions will be detected and reported to the off-board tester during diagnostics in the form of a diagnostic trouble code.
Purpose
The information within this section is designed to diagnose J1850 communication network concerns.
These concerns may:
^ affect normal functional operations of the vehicle.
^ be directly related to customer concerns.
^ be undetectable except during diagnostics.
To properly diagnose a network concern, follow the diagnostic procedure.
Module Identification
Modules included on this J1850 communication network include:
Powertrain Control Module (PCM):
^ located in the engine compartment on the passenger side of the dash panel.
^ a failure of the communication network to the powertrain control module may result in a no start condition.
^ if communication to the powertrain control module fails during diagnosis, see Communication Systems Diagnostics.
Electronic Automatic Temperature Control (EATC)
^ located on the A/C evaporator core housing on the passenger side of the vehicle.
^ loss of communication to powertrain control module may result in degraded automatic temperature control.
^ if communication to the electronic automatic temperature control module is lost.