Operation CHARM: Car repair manuals for everyone.

EGR Valve: Service and Repair

REMOVAL

WARNING: EGR components transport hot exhaust gases. Contact with hot EGR components may cause severe burns. Wear protective gloves or allow the vehicle sufficient time to cool.


EGR System Components:






1. Disconnect the EGR valve tube from the EGR tube connector at the exhaust manifold. Hold the connector with a wrench while disconnecting to avoid damaging the tube.
2. Disconnect the vacuum hoses from the EGR tube, and the EGR valve.
3. Remove the two mounting bolts from the EGR valve, and remove the EGR valve and EGR tube as an assembly. Discard the EGR valve gasket.

INSTALLATION

1. If previously separated, connect the EGR tube to the EGR valve, and finger tighten the EGR nut.
2. Install the EGR valve to the engine with a new gasket. Install the two EGR valve mounting bolts, and torque to 20-30 Nm (15-22 lb-ft).
3. Raise the vehicle for access if necessary, and install the EGR valve tube into the connector on the exhaust manifold. Torque the line nut to 35-45 Nm (26-33 lb-ft), while holding the connector with a wrench to avoid damage to the tube.
4. Tighten the EGR valve line nut at the EGR valve, and torque to 35-45 Nm (26-33 lb-ft).
5. Lower the vehicle if it was raised, and install the EGR tube and EGR valve vacuum hoses.
6. Refer to Powertrain Management/Emission Control Systems/Exhaust Gas Recirculation/Testing and Inspection/Procedures, and test EGR operation.