Speed Control/Horn Brush Contact Plate

1. Disarm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2. Remove four nut and washers retaining air bag module to the steering wheel.
3. Disconnect air bag electrical connector from clockspring contact connector.
4. Remove air bag module from steering wheel. Place air bag module on a flat surface with the trim cover facing up.
5. Remove and discard steering wheel attaching bolt.
6. Grasp rim of steering wheel at opposing points, then pull steering wheel from shaft. Do not use steering wheel puller.
7. Remove tilt lever, if equipped, ignition lock cylinder, then the lower trim panel and lower steering column shroud.
8. Separate speed control brush wire harness from the connector, then remove the wire harness retainers from the steering column.
9. Remove screw securing brush assembly to upper steering column.
10. Reverse procedure to install. Torque the new steering wheel retaining nut to 23-33 ft. lbs.
11. Reactivate airbag as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.