Ground Brush
Fig. 31 Ground Brush Replacement. Continental, Sable & Taurus:
1. Remove steering wheel hub horn pad cover by removing two screws from back of steering wheel.
2. Remove and discard steering wheel attaching nut.
3. Using a puller, remove steering wheel from shaft. To prevent damage never hit steering wheel attaching bolt or use a knock-off type steering wheel puller.
4. Remove tilt lever from steering column, if equipped.
5. Remove ignition lock cylinder.
6. Remove steering column lower trim shroud.
7. Separate speed control brush wire harness at connector, Fig. 31, then remove wire retainers from steering column.
8. Remove brush assembly retaining screw, then brush assembly.
9. Reverse procedure to install, noting the following:
a. Torque steering wheel retaining nut to 23-33 ft. lbs.