Shift Cable: Adjustments
1. Remove the split pin and washer securing the trunnion to the gear change lever at the gearbox and disconnect the trunnion from the lever.
2. Select neutral gear at the gearbox using the gear change lever.
3. Release the clamp securing the outer selector cable, the clamp is attached to a bracket which is mounted on the side of the gearbox extension housing.
4. Select neutral gear, at the gear shift, within the vehicle.
5. Rotate the trunnion clockwise or counter clockwise, until the trunnion will engage with the gear change lever at the gearbox, fit the trunnion and secure in position using a NEW cotter pin and washer.
6. Tighten the outer cable clamp to 22-28 Nm (16-21 ft lb).
7. Reconnect the battery leads.
8. Ensuring the vehicle is on level ground with the parking brake applied, check the oil level while engine is running at idle with neutral selected, after selecting each gear.