Work Procedure

PARTS REQUIRED:

QUANTITY DESCRIPTION PART NO.

1 Clip 50641
1 Grommet 589254
1 Bolt, 8X16 mm SH108161
1 Washer, 8 mm WA108051

PROCEDURE:





1. Place the transmission selector in park.

2. Fit the split grommet around the forward end of the selector cable housing just behind the dust seal.

3. Carefully spread the clip and fit it around the grommet with the tang facing upward and the flat portion of the clip next to the transmission case. Make sure the clip does not pinch the raised ends of the grommet.

4. Move the grommet/clip as required to align with the lower tapped hole in the transmission case.

5. Install the 8 = bolt and washer and torque to 17-20 nM (12-15 ft. lbs.). Bend the clip as needed to centralize the cable in the grommet and eliminate any side pressure on the cable housing.

6. Operate the shift lever through all ranges several times to check for proper selector cable operation and indexing.