Operation CHARM: Car repair manuals for everyone.

AP System

Removal
1. Disconnect the battery negative lead.
2. Remove the lower dash panel fasteners, lower the panel to gain access to the electrical connections at the rheostat switch and bulb check unit. Disconnect the leads and remove the lower dash from the vehicle. Detach the trim pad from around the pedal assembly.





3. Disconnect the electrical leads from the stop light switch.
4. Remove the vacuum hose and disconnect the electrical plug to the cruise control brake vent switch.
5. Disconnect the servo operating rod from the brake pedal.
6. Remove the four nuts and spring washers securing the brake pedal and servo assemblies to the engine compartment closure panel.
7. Withdraw the pedal assembly from the vehicle.

Dismantling





8. Disconnect the pedal return spring.
9. Remove the circlip from the D shaped end of the pedal shaft.
10. Withdraw the pedal shaft.
11. Withdraw the pedal from the box.
12. Remove the bushes from the pedal pivot tube.

Assembling
13. Press the new bushes into the pedal pivot tube. If necessary, ream the bushes to 15.87mm + 0.05mm (0.625 in + 0.002 in).
14. Lightly oil the bushes and pedal shaft.

Refit
15. Refit the assembly to the engine compartment closure panel, tighten the four nuts securely.
16. Connect the electrical leads to the stop light switch.





17. Connect the servo operating rod to the brake pedal with the pivot bolt eccentric, in the forward position. Do not fully tighten the pivot bolt nut.
18. Turn the pivot bolt to bring the brake pedal back until it just contacts the rubber buffer, then secure the pivot bolt nut.
19. Check the cruise control brake switch vent valve setting. Brake Switch (Cruise Control)
20. Clip the lower trim pad into position and refit the lower dash.
21. Re-connect the battery.