Steering Angle Sensor: Service and Repair
Steering Angle SensorRemoval
1. Remove the cover and disconnect the battery ground cable.
2. Make the SRS system safe.
3. Remove the steering wheel.
4. Remove the instrument panel, lower trim panel.
5. Remove the steering column lower cowl.
^ Remove the 2 screws.
^ If installed, disconnect the steering column and foot pedal control switch electrical connector.
6. Remove the steering column upper cowl.
^ Remove the 3 screws.
7. Release the multifunction switch.
^ Depress the 2 clips.
^ Repeat the above procedure on the opposite hand.
8. Release the clockspring.
^ Remove the 4 Torx bolts.
9. Remove the steering angle sensor.
^ Disconnect the electrical connector.
^ Release the 3 wiring harness clips.
^ Separate the harness.
^ Remove the 2 bolts.
^ Remove the reluctor ring.
Installation
1. Install the steering angle sensor.
^ Install the reluctor ring.
^ Tighten the bolts to 3 Nm (2.2 lb.ft).
^ Connect the electrical connector.
^ Secure the clips.
2. Install the clockspring.
^ Tighten the Torx bolts to 6 Nm (4 lb.ft).
3. Install the steering column upper cowl.
^ Install the screws.
4. Install the steering column lower cowl.
^ If installed, connect the steering column and foot pedal switch electrical connector.
^ Secure in the clips.
^ Install the screws.
5. Install the instrument panel, lower trim panel.
6. Install the steering wheel.
7. Connect the battery ground cable and install the cover.
8. Connect WDS and configure the steering angle sensor.