Operation CHARM: Car repair manuals for everyone.

Camshaft Position (CMP) Sensor LH (18.31.12)



Camshaft Position (CMP) Sensor LH (18.31.12)

Removal

1. Remove the intake air resonator.
2. Disconnect the CMP sensor electrical connector.
- Slide the red connector latch to one side.







3. Remove the CMP sensor.
- Remove the Torx bolt.
- Remove and discard the O-ring seal.







Installation
1. Install the CMP sensor.
- Clean the components.
- Install a new O-ring seal.
- Tighten the Torx bolt to 7 Nm (5 lb.ft).
- Connect and secure the electrical connector.
2. Install the intake air resonator.