Vehicles Without: Convertible Top
Tire Pressure Monitoring System Module - Vehicles Without: Convertible TopRemoval
1. Remove the cover and disconnect the battery ground cable.
2. Remove the rear seat backrest.
3. Release the auxiliary junction box mounting bracket.
^ Remove the 3 nuts.
4. Remove the tire pressure monitoring module.
^ Remove the 2 nuts.
^ Disconnect the 2 electrical connectors.
Installation
1. Install the tire pressure monitoring module.
^ Tighten the nuts to 10 Nm (7 lb.ft).
^ Connect the electrical connectors.
2. Secure the auxiliary junction box mounting bracket.
^ Tighten the nuts to 10 Nm (7 lb.ft).
3. Install the rear seat backrest.
4. Connect the battery ground cable and install the cover.
5. Using WDS, configure a new module.