Rear
Brake Caliper - Vehicles With: Standard BrakesRemoval
WARNING: Failure to release the tension and calibrate the electric parking brake during rear parking brake related service procedures, could cause the parking brake to function incorrectly or become inoperative.
CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the LH rear wheel and tire.
3. Release the parking brake cable tension.
4. CAUTION: Always plug any open connections to prevent contamination.
NOTE: To prevent the loss of brake fluid, using the special tool apply the brake pedal and set to 40mm (1.6 in) below the rest position.
Disconnect the brake hose from the brake caliper.
>Using the special tool, press and hold the brake pedal.
>Remove and discard the two sealing washers.
5. Remove the LH anti-rattle spring.
> Release the 2 clips.
6. Disconnect and release the parking brake cable from the caliper.
> Release the clip.
7. Remove the LH brake caliper.
> Remove the 2 access plugs.
> Release the 2 brake caliper guide pins.
8. Remove the brake pads.
9. NOTE: Do not disassemble further if the component is removed for access only.
Remove the brake caliper anchor plate.
> Remove and discard the 2 bolts.
Installation
1. Install the brake caliper anchor plate.
> Clean the component mating faces.
> Tighten the bolts to 103 Nm (76 lb.ft).
2. Install the LH brake pads.
3. Install the LH brake caliper.
> Tighten the guide pins to 28 Nm (21 lb.ft).
> Install the access plugs.
4. Install the LH anti-rattle spring.
> Carefully secure the clips.
5. Connect the brake hose to the brake caliper.
> Install new sealing washers.
> Tighten the union to 35 Nm (26 lb.ft).
6. Connect the parking brake cable.
Carefully secure the clips.
7. Install the wheel and tire.
8. Bleed the brake system.