Operation CHARM: Car repair manuals for everyone.

Performance Brakes

Brake Caliper - Vehicles With: High Performance Brakes

Special Service Tools





Removal

CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.

1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
2. Remove the front wheel and tire.
3. CAUTION: Always plug any open connections to prevent contamination.

NOTE: To prevent the loss of brake fluid, using the special tool apply the brake pedal and set to 40 mm 1.6 in below the rest position.

Disconnect the brake hose from the brake caliper.

> Using the special tool, press and hold the brake pedal.
> Remove and discard the two sealing washers.





4. Remove the anti-rattle spring.
> Release the clip.





5. Remove the brake caliper.
> Remove the 2 access plugs.
> Release the 2 brake caliper guide pins.





6. Release the inboard brake pad from the caliper.
> Release the clip.





7. Remove the outboard brake pad.





Installation
1. Install the brake pads.

> Clean the component mating faces.
> Secure the inboard brake pad in the clip.
> Position the outboard brake pad.

2. Install the brake caliper.

> Tighten the guide pins to 58 Nm (43 lb.ft).
> Install the access plugs.

3. Install the anti-rattle spring.

> Carefully secure the clip.

4. Connect the brake hose to the brake caliper.

> Install new sealing washers.
> Tighten the union to 35 Nm (26 lb.ft).

5. Install the front wheels and tires.
6. Bleed the brake system.