Operation CHARM: Car repair manuals for everyone.

Differential Axle Housing: Service and Repair

Fig. 3 Setting trim height:





1. Support vehicle on jack stands.
2. Remove both wheel and tire assemblies.
3. Remove parking brake cable mounting bolt and clip.
4. Disconnect brake hose.
5. Remove stabilizer bar retaining bolts then the stabilizer bar.
6. Place a floor jack under axle then remove right and left shock absorber retaining bolts then the shock absorber.
7. Lower floor jack then remove right and left coil spring and insulating rings.
8. Remove right and left rear axle retaining bolts.
9. Remove rear axle control arm and bushing.
10. Reverse procedure to install, noting the following:
a. Set rear trim height to 15 inches Fig. 3, then torque control arm mounting bolts to 72.3 ft. lbs.
b. Install new lower shock absorber retaining bolts and torque to 29.7 ft. lbs.
c. Torque stabilizer retaining bolts to 20.3 ft. lbs.
d. Torque brake hose to 11.6 ft. lbs.