Operation CHARM: Car repair manuals for everyone.

CAN




MAIN LINE BETWEEN TCM AND DLC CIRCUIT

Diagnosis Procedure


1. CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

1.Turn the ignition switch OFF.
2.Disconnect the 12V battery cable from the negative terminal.
3.Disconnect the following harness connectors.
- ECM
-Harness connectors F103 and M116
-Harness connectors M105 and M181
4.Check the continuity between the harness connectors.





Is the inspection result normal?
YES (Present error)-Check CAN system type decision again.
YES (Past error)-Error was detected in the main line between the TCM and the data link connector.
NO- Replace the PCB harness.