Expansion Valve: Service and Repair
Removal and Installation of Expansion ValveREMOVAL
1. Remove engine cover and air cleaner cover. Refer to "ENGINE ROOM COVER".
2. Use a refrigerant collecting equipment (for HFC-134a) to discharge the refrigerant.
3. Drain coolant from cooling system and disconnect heater hoses. Refer to "Changing Engine Coolant".
4. Disconnect low-pressure flexible hose and high-pressure pipe from evaporator.
CAUTION: Cap or wrap the joint of low-pressure flexible hose and high-pressure pipe with a suitable material such as a vinyl tape to avoid the entry of air.
5. Remove expansion valve cover.
6. Remove expansion valve.
INSTALLATION
Installation is basically the reverse order of removal.
CAUTION:
- Replace O-rings with new ones, then apply compressor oil to them when installing them.
- When recharging refrigerant, check for leaks.