Operation CHARM: Car repair manuals for everyone.

Vehicle Does Not Creep Forward In D Position

Vehicle Does Not Creep Forward In "D" Position)

SYMPTOM: Vehicle does not creep forward when selecting "D" position.

DIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSTIC RESULTS
Execute self-diagnosis.
Do the self-diagnostic results indicate accelerator pedal position sensor, CAN communication line, PNP switch?
Yes >>Check the malfunctioning system. Refer to "DTC P1705 THROTTLE POSITION SENSOR", "DTC U1000 CAN COMMUNICATION LINE", "DTC P0705 PARK/NEUTRAL POSITION SWITCH".
No >>GO TO 2.

2. CHECK CONTROL LINKAGE





Check the control linkage.
Refer to "Checking of A/T Position".
OK or NG
OK >> GO TO 3.
NG >> Adjust control linkage. Refer to "Adjustment of A/T Position".

3. CHECK A/T FLUID LEVEL





Check A/T fluid level again. Refer to "Checking A/T Fluid".
OK or NG
OK>> GO TO 4.
NG>> Refill ATF.

4. CHECK STALL TEST





Check stall revolution with selector lever in "M position. Refer to "STALL TEST". Stall Test
OK or NG
OK>> GO TO 5.
NG>> GO TO 7.

5. CHECK LINE PRESSURE





Check line pressure at idle with selector lever in "D" position. Refer to "LINE PRESSURE TEST". Line Pressure Test
OK or NG
OK>> GO TO 8.
NG - 1 >> Line pressure high. GO TO 6.
NG - 2 >> Line pressure low. GO TO 7.

6. DETECT MALFUNCTIONING ITEM
1. Control valve assembly. Refer to "Control Valve Assembly."
2. Disassemble A/T. Refer to "DISASSEMBLY".
3. Check the following items:
- Oil pump assembly. Refer to "Oil Pump".
OK or NG
OK>> GO TO 8.
NG>> Repair or replace damaged parts.

7. DETECT MALFUNCTIONING ITEM
1. Control valve assembly. Refer to "Control Valve Assembly."
2. Disassemble A/T. Refer to "DISASSEMBLY".
3. Check the following items:
- Oil pump assembly. Refer to "Oil Pump".
- Powertrain system. Refer to "DISASSEMBLY".
- Transmission case. Refer to "DISASSEMBLY".
OK or NG
OK>> GO TO 8.
NG>> Repair or replace damaged parts.

8. CHECK A/T FLUID CONDITION





1. Remove oil pan. Refer to "Control Valve Assembly".
2. Check A/T fluid condition.
OK or NG
OK>> GO TO 9.
NG>> GO TO 12.

9. DETECT MALFUNCTIONING ITEM
Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to "Symptom Chart". Symptom Chart
OK or NG
OK>> GO TO 10.
NG>> Repair or replace damaged parts.

10. CHECK SYMPTOM
Check again.
OK or NG
OK >> INSPECTION END
NG>> GO TO 11.

11. CHECK TCM
1. Check TCM input/output signals. Refer to "TCM Input/Output Signal Reference Values". Pinout Values and Diagnostic Parameters
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG>> Repair or replace damaged parts.

12. DETECT MALFUNCTIONING ITEM
Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to "Symptom Chart". Symptom Chart
OK or NG
OK>> GO TO 10.
NG>> Repair or replace damaged parts.