Removal and Installation
Removal and InstallationREMOVAL
1. Remove battery.
2. Remove air intake duct. Refer to "AIR CLEANER AND AIR DUCT" in "ENGINE MECHANICAL (EM)" section.
3. Remove alternator, water pump and A/C compressor belt. Refer to "Removal and Installation" in "ENGINE MECHANICAL (EM)" section.
4. Remove alternator mounting bolts.
5. Remove power steering hose clamp mounting bolt.
6. Remove alternator stay mounting bolts and alternator stay.
7. Remove battery ground harness mounting bolt.
8. Remove alternator bracket mounting bolts and alternator bracket.
9. Disconnect alternator connector.
10. Remove B terminal nut.
11. Remove alternator ground harness mounting bolt.
12. Remove power steering oil reservoir tank mounting bolts, then slide power steering oil reservoir tank.
13. Remove alternator assembly from vehicle upper side.
INSTALLATION
Install in the reverse order of removal, taking care of the following point.
- Install alternator, and check tension of belt. Refer to "Checking Drive Belts" in "ENGINE MECHANICAL (EM)" section.
CAUTION: Be sure to tighten B terminal nut carefully.
B terminal nut:
Torque: 9.4 - 10.7 Nm (0.95 - 1.1 kg-m, 83 - 95 in-lb)
Alternator ground harness mounting bolt:
Torque: 2.3 - 2.6 Nm (0.23 - 0.27 kg-m, 20 - 23 in-lb)
Battery ground harness mounting bolt:
Torque: 10 - 11 Nm (1.0 - 1.2 kg-m, 87 - 104 in-lb)
Power steering hose clamp mounting bolt:
Torque: 7.9 - 10.7 Nm (0.8 - 1.1 kg-m, 70 - 95 in-lb)
Power steering oil reservoir tank mounting bolt:
Torque: 16 - 20 Nm (1.6 - 2.0 kg-m, 12 - 15 ft-lb)
Alternator bracket mounting bolt:
Torque: 57 - 65 Nm (5.8 - 6.7 kg-m, 42 - 48 ft-lb)
Alternator mounting bolt (upper side):
Torque: 60 - 69 Nm (6.1 - 7.1 kg-m, 45 - 51 ft-lb)
Alternator stay mounting bolt:
Torque: 21 - 26 Nm (2.1 - 2.7 kg-m, 16 - 19 ft-lb)
Alternator mounting bolt (lower side):
Torque: 21 - 26 Nm (2.1 - 2.7 kg-m, 16 - 19 ft-lb)