Operation CHARM: Car repair manuals for everyone.

Cylinder Head

Cylinder Head Torque and Sequence





Follow the steps below to tighten fixing bolts in the order shown in figure to install cylinder head.

CAUTION:
If cylinder head bolts are re-used, check their outer diameters before installation.

Apply engine oil to threads and seating surface of bolts.
Tighten all bolts to 98.1 Nm (10 kg-m, 72 ft. lbs.).
Completely loosen all bolts.
Tighten all bolts to 39.2 to 49.0 Nm (4.0 to 5.0 kg-m, 29 to 36 ft. lbs.).
Turn all bolts 60 to 65 (target: 60) degrees clockwise.





Turn all bolts 60 to 65 (target: 60) degrees clockwise again.

Outer Diameter of Cylinder Head Bolts





^ Cylinder head bolts are tightened by plastic zone tightening method. Whenever the size difference between d1 and d2 exceeds the limit, replace them with new one.
Limit (d1 - d2) More than 0.18 mm (0.0071 inch)
^ If reduction of outer diameter appears in a position other than d2, use it as d2 point.