Operation CHARM: Car repair manuals for everyone.

Vehicle Does Not Creep Forward In D Position

Vehicle Does Not Creep Forward In "D" Position

SYMPTOM: Vehicle does not creep forward when selecting "D" position.

DIAGNOSTIC PROCEDURE
1. CHECK A/T FLUID LEVEL
Check A/T fluid level again. Refer to "Checking A/T Fluid".
OK or NG
OK>> GO TO 2.
NG>> Refill ATF.

2. CHECK SELF-DIAGNOSTIC RESULTS
Execute self-diagnosis.
Do the self-diagnostic results indicate accelerator pedal position sensor, CAN communication line, PNP switch?
Yes >>Check the malfunctioning system. Refer to "DTC P1705 THROTTLE POSITION SENSOR", "DTC U1000 CAN COMMUNICATION LINE", "DTC P0705 PARK/NEUTRAL POSITION SWITCH".
No >>GO TO 3.

3. CHECK LINE PRESSURE
Check line pressure at idle with selector lever in "R" position. Refer to "LINE PRESSURE TEST".
OK or NG
OK>> GO TO 4.
NG >> Check line pressure solenoid valve. Refer to "DTC P0745 LINE PRESSURE SOLENOID VALVE".

4. CHECK CONTROL LINKAGE
Check the control linkage.
Refer to "Checking of A/T Position".
OK or NG
OK>> GO TO 5.
NG>> Adjust control linkage. Refer to "Adjustment of A/T Position".

5. CHECK SYMPTOM
Check again.
OK or NG
OK >> INSPECTION END
NG>> GO TO 6.

6. PERFORM TCM INSPECTION
1. Perform TCM input/output signal inspection.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG>> Repair or replace damaged parts.