Operation CHARM: Car repair manuals for everyone.

Rear Door Window Regulator: Service and Repair

Rear:






REMOVAL
1. Remove rear door finisher. Refer to "DOOR FINISHER"
2. Remove rear door speaker. Refer to "Removal and Installation of Door Speaker"
3. Remove rear door outside molding. Refer to "DOOR OUTSIDE MOLDING"
4. Remove door screen assembly.
5. Remove glass stopper and inner stabilizer.




6. Operate power window sub-switch to raise/lower door window until glass mounting bolts can be seen.
7. Remove glass mounting nuts.




8. Remove glass guide from glass channel while lifting the whole.
9. Pull out back guide roller from guide rail and detach glass.
10. Remove the harness connector routed on the frame assembly, then remove the harness clip from the back.




11. Remove bolt of sub-channel and regulator then remove regulator assembly.
12. Remove bolt of guide channel then remove guide channel.

INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
- Gear wear
- Regulator deformation
- Spring damage
- Grease condition for each sliding part