Cruise Test - Part 1
Cruise test Part 11. STARTING OUT FROM D1
1. Drive the car for about 10 minutes to warm up the engine oil and A/T fluid. Appropriate temperature for the A/T fluid: (50 - 80°F)
2. Park the vehicle on a level surface.
3. Move selector lever to "P" position.
4. Engage the engine.
5. Move selector lever to "D" position.
6. Press the accelerator pedal about half way down to accelerate the vehicle.
With CONSULT-II
Read off the gear positions.
Starts from D1?
YES >> GO TO 2.
NO >> Enter a check mark at "Vehicle can not be started from D1" on the diagnostics sheet, then continue the road test.
2. SHIFT UP D1 - D2
Press down the accelerator pedal about half way and inspect if the vehicle shifts up (D1 - D2) at the appropriate speed.
with CONSULT-II
Read the gear position, throttle degree of opening, and vehicle speed.
Does the A/t shift up D1 - D2 at the correct speed?
YES >> GO TO 3.
NO >> Enter a check mark at "A/T does not shift D1 - D2 or does not kick down D4 - D2" on the diagnostics sheet, then continue the road test.
3. SHIFT UP D2 - D3
Press down the accelerator pedal about half way and inspect if the vehicle shifts up (D2 - D3) at the appropriate speed.
With CONSULT-II
Read the gear position, throttle degree of opening, and vehicle speed.
Does the A/t shift up D2 - D3 at the correct speed?
YES >> GO TO 4.
NO >> Enter a check mark at "A/T does not shift D2 - D3" on the diagnostics sheet, then continue the road test.
4. SHIFT UP D3 - D4
Press down the accelerator pedal about half way and inspect if the vehicle shifts up (D3 - D4) at the appropriate speed.
With CONSULT-II
Read the gear position, throttle degree of opening, and vehicle speed.
Does the A/t shift up D3 - D4 at the correct speed?
YES >> GO TO 5.
NO >> Enter a check mark at "A/T does not shift D3 - D4" on the diagnostics sheet, then continue the road test.
5. SHIFT UP D4 - D5
Press down the accelerator pedal about half way and inspect if the vehicle shifts up (D4 - D5) at the appropriate speed.
With CONSULT-II
Read the gear position, throttle degree of opening, and vehicle speed.
Does the A/T shift up D4 - D5 at the correct speed?
YES >> GO TO 6.
NO >> Enter a check mark at "A/T does not shift D4 - D5" on the diagnostics sheet, then continue the road test.
6. LOCK-UP
Press down the accelerator pedal about half way and inspect if the vehicle lock-up (D5 - L/U) at the appropriate speed.
With CONSULT-II
Select "TCC SOL 0.00A" with the "MAIN SIGNAL" mode for A/T.
Does the A/T lock-up at the correct speed?
YES >> GO TO 7.
NO >> Enter a check mark at "A/T does not perform lock-up" on the diagnostics sheet, then continue the road test.
7. LOCK-UP HOLD
Is the lock-up held for at least 30 seconds?
YES >> GO TO 8.
NO >> Enter a check mark at "A/T hold does not lock-up condition" on the diagnostics sheet, then continue the road test.
8. LOCK-UP RELEASE
Release the accelerator pedal. When you release the accelerator pedal, is the lock-up released?
YES >> GO TO 9.
NO >> Enter a check mark at "Lock-up is not released" on the diagnostics sheet, then continue the road test.
9. SHIFT DOWN D5 - D4
Decelerate by pressing lightly on the brake pedal.
With CONSULT-II
Read the gear position and engine speed.
When the A/T shift down D5 - D4, does the engine speed drop smoothly back to idle?
YES >>
1. Stop the car.
2. GO TO Cruise test - Part 2.
NO >> Enter a check mark at "A/T does not shift down" on the diagnostics sheet, then continue the road test.