Traction Control - VDC System 'SLIP' Light ON
Classification:BR02-005
Reference:
ITB02-047
August 12, 2002
2002 I35; VDC SYSTEM "SLIP" LIGHT COMES ON
APPLIED VEHICLE:
2002 I35 (CA33)
APPLIED VIN:
Vehicles built before: JNKDA31A52T030649
APPLIED DATE:
Vehicles built before: June 20, 2002
SERVICE INFORMATION
If the Vehicle Dynamic Control (VDC) "Slip" light comes on under the following conditions:
^ During "banked", tight-radius turns with the steering wheel angle greater than 80 degrees
^ Vehicle speed is in the 28 - 30 MPH range,
Use this bulletin to determine if the Anti-Skid Control Module needs replacement.
NOTE:
The "Slip" light indicates that the VDC system is activated. As a result, the customer may notice a mechanical noise (similar to ABS activation) and a brief slowing or hesitating sensation of the vehicle.
SERVICE PROCEDURE
1. Confirm the incident as follows:
A. Have the customer describe exactly where the incident occurred. You may have to return to this same location to verify the incident.
B. Road test the vehicle on a dry, paved road surface as described in the Service Information, above and according to the customer.
IMPORTANT:
^ Remember, it is important that you road test the vehicle according the above listed conditions and just as the customer describes in order to correctly duplicate the incident.
^ It is normal for the VDC system to activate (and turn on the "Slip" light) when the vehicle experiences poor traction or the performance limits (of VDC) are exceeded.
^ This bulletin does not apply if the "Slip" light comes on ONLY when driving:
- On paved roads under wet, icy, or snow conditions
- On dirt/gravel, or sandy roads
- On roads that are rutted, broken up, poorly patched, or in "very poor" condition
- During aggressive or high speed driving at or near the vehicle's handling performance limits
2. Check for stored DTC(s) in the ABS/VDC system:
A. If a DTC(s) is stored, diagnose and repair according to the Electronic Service Manual (ESM) and proceed to step 3 (below).
B. If no DTC(s) is stored, proceed to step 3 (below).
3. Replace the Anti-Skid Control Module with the one listed in the Parts Information table as follows:
A. Record all radio station pre-sets.
B. Disconnect the negative battery cable.
C. Remove the driver's seat.
D. Remove the old module and install the new one.
E. Re-install the driver's seat.
4. Re-connect the negative battery cable.
5. Turn the ignition key to the ON position and re-program all radio station pre-sets.
6. Re-set the interior clock.
7. If equipped, re-set the sun roof memory as follows:
^ If the sunroof is open, press the tilting switch repeatedly toward tilt "Down" to fully close the sunroof (see Figure 1).
^ After the sunroof has closed all the way, keep pressing the tilting switch toward tilt "Down" for more than one second.
8. Confirm the incident is resolved by road testing the vehicle according the conditions listed and just as the customer described.
PARTS INFORMATION
CLAIMS INFORMATION
Submit a Primary Failed Part (PP) line claim using the claims coding shown.