Operation CHARM: Car repair manuals for everyone.

Repair procedures





Inspection

1. Turn the ignition switch OFF.
2. Disconnect the temperature control actuator connector.
3. Verify that the temperature control actuator operates to the hot position when connecting 12V the terminal 3 and grounding terminal 7.
Verify that the temperature control actuator operates to the cool position when connected in reverse.









4. Connect the mode control actuator connector.
5. Turn the ignition switch ON.
6. Check the voltage between terminals 5 and 6.
Specification





It will feedback the current position of the actuator to controls.
7. If the measured voltage is not within specification, substitute with a known-good temperature control actuator and check for proper operation.
8. Replace the temperature control actuator if it is proved that there is a problem with it.

Replacement

1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad left side cover (A).




3. Remove the extension cover.

4. Remove the crash pad lower cover (A).




5. Disconnect the connector (A) and diagnosis connector (B) and then remove the crash pad lower cover.








6. Remove the reinforcing panel (A).




7. Remove the shower duct (A).




8. Remove the BCM (A).




9. Disconnect the temperature control actuator connector (A).
10. Loosen the mounting screw and then remove the temperature control actuator (B).

[Driver's side]




11. Remove the right extension cover (A).




12. Remove the crash pad lower cover (A).




13. Disconnect the connector (A) and then remove the crash pad lower cover.




14. Remove the crash pad garnish (A).




15. Remove the center facia panel (A).




16. Disconnect the damper (B) from the glove box (A) and then remove the glove box lift (C).








17. Disconnect the pin (A), then remove the glove box (B).








18. Remove the glove box housing (A).




19. Remove the shower duct (A).




20. Disconnect the temperature control actuator connector (A).
21. Loosen the mounting screw and then remove the temperature control actuator (B).

[Passenger's side]




22. Install in the reverse order or removal.