Input Shaft Reassembly
INPUT SHAFTREASSEMBLY
1. Insert the input shaft into the spacer (A).
2. Heating the 5th input gear with a heat gun (A), insert the input shaft (C) into it with a press (D).
3. Using a press (B), do the same procedure as described above with the front side taper roller bearing (A) for its installation.
4. Select the front side snap ring (A) which makes the gap be 0 - 0.03 mm (0.0012 inch), and install it.
5. Heating the 3rd/4th gear (B) with a heat gun, insert the input shaft (rear side) into it with a press (A).
6. Using a press (B), do the same procedure as described above with the rear side taper roller bearing (A) for its installation.
7. Select the rear side snap ring (A) which makes the gap be 0 - 0.03 mm (0.0012 inch), and install it.
