M/T Control Shaft Assembly - Service Procedure
Number:00-40-003
Group:
TRANSAXLE
Date:
FEBRUARY, 2000
Subject:
2000 ACCENT CONTROL SHAFT ASSEMBLY SERVICE PROCEDURE
Model:
2000 ACCENT
DESCRIPTION:
Effective 01/03/2000 with transaxle serial number 279701, the control shaft design on 2000 MY Accents with manual transaxles has been changed from a "reamer bolt" to a "lock-pin" design to secure the control finger to the shaft.
The 2000 model Accent shop manual and the transaxle overhaul manual (publication number: PESE AOO6A) do not provide a service procedure for assembling the control shaft components. The service procedure follows:
NOTE:
When any 2000 MY Accent manual transaxle is being overhauled, replace the reamer bolt design components with the new lock-pin design control shaft as a matter of course.
VEHICLES AFFECTED
2000 model Accent vehicles produced before 01/03/2000 with M5AF3 manual transaxles with serial numbers less than 279701.
NOTE:
Refer to Shop Manual procedures for transaxle removal, disassembly, assembly and installation.
SERVICE PROCEDURE - CONTROL SHAFT DISASSEMBLY:
1. Remove the interlock bolt (10 mm) from the control shaft assembly.
2. Pull the control shaft assembly out as shown.
SERVICE PROCEDURE CONTROL SHAFT ASSEMBLY:
The photo shows the individual control shaft components required for the assembly. They are placed in appropriate order for assembly.
1. Attach the rubber boot to the clutch housing side wall.
2. Insert the control shaft.
3. Slide the control finger inside the interlock plate, and then slide the assembly onto the control shaft.
4. Install the stopper plate on the control shaft.
5. Install the neutral return spring as shown.
6. Install the lock-pin using the punch provided with the control shaft kit (any equivalent punch may be used).
NOTE:
In a fully installed position, the pin head may stick out up to 1 mm above the control finger surface (do not force the pin head flush with the control finger surface).
7. Washer Application
A washer, P/N 43750-25000, is supplied with the control shaft kit components. This washer should be installed below the shift cable eyelet on the control shaft lever pin. Add this washer if the vehicle production date is 10/05/99 or earlier (transmission serial number: 223631 or less).
NOTE:
Do not use this washer on any Accent vehicles produced after 10/05/99 production.
PARTS INFORMATION:
NOTE:
The control shaft kit contains the five components shown. Any components not supplied in the kit should be used from the control shaft being replaced.
Interchangeability
WARRANTY INFORMATION: REQUIRED CONTROL SHAFT REPLACEMENT AS PRIMARY REPAIR.
WARRANTY INFORMATION - CONTROL SHAFT REPLACEMENT AS PART OF OTHER MTA OVERHAUL WORK