Operation CHARM: Car repair manuals for everyone.

Starter Assembly

INSTALL OR CONNECT
1. Lightly grease the front and rear armature bearings with GM #1050109 and install the armature into the field frame.
2. Brushes into brush holder while holding the brush springs with a screwdriver. Make certain that the positive (+) lead wires are not grounded to the brush holder or the field frame.
3. A new O-ring to the field frame.
4. End cover to field frame; secure with two screws.
5. Lightly grease the steel ball with GM #1050109 and install to the clutch and drive assembly.
6. Idler gear to drive housing assembly.
7. Roller bearing to drive housing assembly.
8. Clutch assembly to drive housing assembly.
9. Pinion return spring to starter solenoid.
10. Steel ball to clutch and drive assembly.
11. Drive housing assembly to starter solenoid; secure with two bolts.
Tighten
^ Drive housing bolts to 5.9 N.m (52 lb. in.).
12. Field frame with armature to starter solenoid assembly; secure with two bolts.
Tighten
^ Starter through bolts to 5.9 N.m (52 lb. in.).
13. Starter solenoid lead wire to starter solenoid terminal; secure with one nut.
Tighten
^ Starter solenoid lead wire nut to 5.9 N.m (52 lb. in.).