Front Toe Adjustment
NOTE:^ Install alignment equipment following equipment manufacturer's instructions. Measure alignment angles and record the readings.
^ Jounce front and rear bumpers three times to normalize suspension prior to measuring angles.
^ If caster or camber angles are not within the specified range, inspect for damaged suspension and steering components and replace parts as necessary.
1. Set steering wheel to the straight ahead position.
2. Remove tie rod boot clamp from left and right tie rod boot.
3. Loosen left and right tie rod end locknuts.
^ Adjust the Front total toe to 0.1 degrees +/- 0.2 degrees by turning left and right tie rods to increase or decrease tie rod end length.
NOTE: The difference between the left tie rod end length and the right tie rod end length must be less than 1.5 mm (0.059 inch).
^ Tighten the left and right tie rod end locknuts to 56 Nm (41 ft. lbs.).
NOTE: Make sure that the tie rod boots are not twisted.
4. Install tie rod boot clamps, securing left and right tie rod boots.