Condenser: Service and Repair
NOISE SUPPRESSOR CONDENSER REPLACEMENTREMOVE OR DISCONNECT
1. Distributor from vehicle. Refer to Distributor Replacement. Service and Repair
Fig 9:
2. Rotor from distributor housing.
3. Ignition coil dust cover and gasket from distributor housing.
Ignition Coil Terminal Nuts:
4. Two nuts and four wires from the ignition coil terminals.
Ignition Coil Screws:
5. Four screws and ignition coil from distributor housing.
Fig 12:
6. One screw and capacitor from distributor housing.
INSTALL OR CONNECT
1. Capacitor to distributor housing; secure with one screw.
2. Ignition coil to distributor; secure with four screws.
3. Four wires to ignition coil terminals; secure with two nuts.
NOTICE: When connecting the wires to the ignition coil, insert them properly into their grooves found on the side of the ignition coil and make sure the wires do not come in contact with the signal rotor or distributor housing.
^ Tighten ignition coil terminal nuts to 8 Nm (71 lb. in.).
4. Ignition coil dust cover and new gasket to distributor housing.
7. Rotor to distributor housing.
8. Distributor to vehicle. Refer to Distributor Replacement.