Operation CHARM: Car repair manuals for everyone.

Wiper Motor Linkage: Service and Repair

WIPER MOUNTING ARM AND PIVOT SHAFT

Removal and Installation

1. CAUTION: The windshield wiper system has an auto-park feature. It is necessary to disconnect the battery.

Disconnect the battery.

2. Remove the 2 windshield wiper pivot arm nut covers.
3. Remove the 2 nuts and the 2 windshield wiper pivot arms.
- To install, tighten to 25 Nm (18 lb-ft).

4. Remove the LH and RH cowl panel grille extension panels.

5. NOTE: The pin-type retainers are reusable.

Remove the 9 pin-type retainers and the cowl panel grille.

6. Remove the 7 bolts and the strut tower support brace.
- To install, tighten to 20 Nm (15 lb-ft).

7. NOTE: When positioning the degas bottle aside, it is necessary to reroute the degas bottle lower hose in front of the brake booster.

Remove the 2 bolts and position the degas bottle aside.
- To install, tighten to 10 Nm (89 lb-in).

8. Disconnect the windshield wiper motor jumper harness.
9. Remove the 4 bolts and the wiper mounting arm and pivot shaft.
- To install, tighten to 12 Nm (9 lb-ft).

10. To install, reverse the removal procedure.