Vehicle Damage Warnings
CAUTION:^ Cover the instrument panel in order to prevent possible damage.
^ Care must be used to avoid scratching the pinch weld.
^ After installing the new urethane-installed glass, the vehicle should not be driven until the urethane adhesive has cured. The curing time at temperatures above 13°C (55°F) and relative humidity above 50% is 12-24 hours. (Refer to the Essex driveaway chart for the cure times as the temperatures and humidity vary.) Inadequate curing of the urethane adhesive may adversely affect the strength of the urethane adhesive bond.
^ All rust found on the pinch weld must be removed and the pinch weld restored to factory specifications. If surface rust is found, remove completely down to clean, bare metal. Prime pinch weld metal with an factory recommended curing automotive paint primer and allow to cure thoroughly. If rust has penetrated through the pinch weld metal, repair the pinch weld sheet metal before proceeding.
^ Wipe off the urethane glass prep immediately after each application because it flash dries. Apply with deliberate strokes, making sure not to overlap the applied area.