Shift Cable: Service and Repair
Selector Lever Cable and BracketRemoval and Installation
1. Position the gearshift lever in the D5 position.
2. Raise and support the vehicle.
3. NOTE: It is not necessary to remove the exhaust.
Remove the bolts from the heat shield and allow the shield to rest on the exhaust.
4. Disconnect the transmission shift cable from the selector lever.
5. Disconnect the transmission shift cable from the bracket.
6. Remove the bolt at the shift cable bracket.
7. Remove the transmission shift cable.
1 Disconnect the shift cable from the transmission manual control lever.
2 Depress the tab and slide the shift cable out of the shift cable bracket.
3 Remove the shift cable.
8. NOTE: A cable adjustment must be performed after the installation procedure.
To install, reverse the removal procedure.
^ Adjust the shifter cable.