Operation CHARM: Car repair manuals for everyone.

Auxiliary Water Pump: Service and Repair

REMOVAL
1. Drain the engine coolant.
2. Remove the engine air cleaner outlet tube.







3. Release the clamp and disconnect the upper radiator hose.







4. Remove the bolt and position aside the receiver/drier.







5. Detach the auxiliary coolant flow pump.
1 Disconnect the electrical connector.
2 Remove the bolts.
6. Raise the vehicle.







7. Release the clamp and disconnect the heater hose at the dual coolant flow valve.
8. Lower the vehicle.







9. Release the clamp and disconnect the heater hose.
10. Remove the auxiliary coolant flow pump with the hoses still attached.
11. If a new auxiliary coolant flow pump is to be installed, transfer the heater hoses from the old unit to the new unit.
- Clean and lubricate the coolant hoses with coolant hose lubricant or plain water only if needed.

INSTALLATION
1. To install, reverse the removal procedure.
- Clean and lubricate the coolant hoses with coolant hose lubricant or plain water only if needed.
2. Refill the engine coolant level.