Heater Core Case
Spring Lock Coupling Disconnect Tool Set:
SPECIAL TOOL(S)
REMOVAL
1. Drain the cooling system. For additional information, refer to Cooling System.
2. Remove the instrument panel. For additional information, refer to: Dashboard/Instrument Panel. Service and Repair
3. Raise and support the vehicle. For additional information, refer to Maintenance/Service and Repair.
4. Disconnect the heater hoses from the heater core.
- Disconnect the vacuum line from the engine.
5. Lower the vehicle.
6. Disconnect the electrical connectors.
1 Disconnect the blower motor electrical connector.
2 Disconnect the blower motor resistor electrical connector.
7. Remove the nut on the heater/evaporator core housing (A/C variant shown).
8. Remove the lower defroster air duct from the heater/evaporator core housing.
1 Remove the screw.
2 Release the retaining tabs.
9. Disconnect the right and left-hand air hose from the heater/evaporator core housing (left-hand side shown).
10. Remove the heater/evaporator core housing.
INSTALLATION
1. To install, reverse the removal procedure.
- Check heating and A/C system for normal operation.