Operation CHARM: Car repair manuals for everyone.

Without Air Conditioning

DISASSEMBLY







1. Remove the Panel (PNL)/Defrost (DEF) vacuum control actuator.
1 Disconnect the connecting rod.
2 Remove the nuts.
3 Disconnect the vacuum lines.
4 Remove the actuator.







2. Remove the Panel (PNL)/Floor (FLR) vacuum control actuator.
1 Disconnect the connecting rod.
2 Remove the nuts.
3 Disconnect the vacuum lines.
4. Remove the actuator.







3. Remove the recirculation/fresh air vacuum control actuator.
1 Disconnect the connecting rod.
2 Remove the nuts.
3 Disconnect the vacuum line.
4. Remove the actuator.

4. Remove the vacuum line harness.







5. Remove the blend door motor.
1 Remove the four screws.
2 Remove the motor.







6. Remove the heater outlet floor duct from the heater/evaporator core housing.
1 Remove the screw.
2 Slide the air duct upwards.
3 Release the retaining tabs on each side and remove the heater outlet floor duct.







7. Remove the heater core cover and core.
- Release the four retaining clips and remove the heater core cover and core.







8. Separate the blower motor/evaporator housing.
- Remove the screws.







9. Remove the evaporator core cover.
1 Remove the bolts.
2 Remove the rubber seal.
3 Remove the evaporator nut and the cover.







10. Remove the air baffle.





11. Remove the upper part of the blower housing.
1 Remove the metal clips (if equipped).
2 Release the eight retaining tabs.







12. Remove the blower motor resistor screw and the resistor.







13. Separate the blower housing lower halves.
- Release the two retaining tabs.







14. Disassemble the blower upper housing.
1 Detach the seal.
2 Release the three retaining tabs.







15. Separate the housing.
1 Release the five retaining tabs.
2 Pull off the clip.







16. Disassemble the housing.
1 Pull out the air door control shafts (two shown).
2 Remove the three air doors.

ASSEMBLY







NOTE: Secure the housing parts with additional Clips as the retaining tabs can be damaged when the housing parts are disconnected.

1. To assemble, reverse the disassembly procedure.