Operation CHARM: Car repair manuals for everyone.

Windshield Washer Switch: Service and Repair

REMOVAL





1. Disconnect the battery ground cable and wait one minute for the air bag backup power supply to be depleted.

WARNING: THE BACKUP POWER SUPPLY ENERGY MUST BE DEPLETED BEFORE ANY AIR BAG COMPONENT REPAIR IS PERFORMED. TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT ONE MINUTE.

2. Remove the steering wheel.





3. Remove the steering column shroud screws and remove the upper and lower steering column shrouds.





4. Disconnect the multi-function switch electrical connectors.





5. Remove the (A) multi-function switch screws and remove the (B) multi-function switch.

INSTALLATION
1. To install, reverse the removal procedure.
- Check multi-function switch adjustment.

NOTE: When battery voltage is removed from the Powertrain Control Module (PCM), all learned values will be cleared and reset to predetermined values. When battery voltage is restored to the PCM, the vehicle may exhibit certain driveability concerns. It will be necessary to drive the vehicle to allow the PCM to relearn values for optimum driveability and performance.