Operation CHARM: Car repair manuals for everyone.

Engine - Stall After Decel/Lacks Power On Acceleration

Article No.
98-13-6

07/06/98

^ LACKS POWER - AFTER CLOSED THROTTLE
DECELERATION - VEHICLES WITH 2.0L ZETEC
ENGINE

^ STALL - DURING DECELERATION AND
"STOP-AND-GO" DRIVING - VEHICLES WITH 2.0L
ZETEC ENGINE

FORD:
1998 ESCORT ZX2

CALIBRATION





Refer to the Recalibration Cross Reference Chart in this TSB article for affected calibrations.

WARNING
THIS MODIFICATION IS AUTHORIZED ONLY FOR THE LISTED ENGINE(S). PERFORMING THIS MODIFICATION ON OTHER ENGINE CALIBRATIONS IS UNAUTHORIZED AND COULD CREATE LIABILITY UNDER APPLICABLE FEDERAL OR LOCAL LAWS.

ISSUE
Some vehicles may exhibit one of the following conditions:

^ Engine may stall after decel to a stop in hot ambient temperatures around 27°C (80° F) or higher.

^ A lack of power (upon acceleration) after coasting downhill at closed throttle and coming to a stop. When attempting to accelerate, the vehicle will experience poor acceleration. This concern occurs usually after the initial start and drive away.

These issues may be caused by either the Vapor Management Valve (VMV) closing too fast and creating a lean condition, or a strategy error causing the transmission to upshift to 4th gear when coming to a stop under certain conditions.

ACTION

Reprogram the Powertrain Control Module (PCM). Refer to the Service Procedure and the Recalibration Cross Reference Chart for the correct PCM calibration.

SERVICE PROCEDURE

1. Perform normal diagnostics as outlined in the 1998 Powertrain Control/Emissions Diagnosis (PC/ED) On-Board Diagnostics II (OBD-II) Service Manual and service as required.

2. It the concern is still present, reprogram the PCM using the July 1998 or later CD-ROM, Service Bay Diagnostic System (SBDS), or New Generation Star (NGS) Tester.

NOTE
PCM REPLACEMENT IS NOT AUTHORIZED BY THIS TSB. REFER TO THE PC/ED SERVICE MANUAL FOR APPROPRIATE DIAGNOSTIC PROCEDURES IF PCM HARDWARE CONCERNS EXIST.





Obtain an Authorized Modifications Decal (FPS 8262 - obtainable through DOES II, 25/pkg) and list the date, dealer number, and summary of modifications performed. Select a prominent place adjacent to the Vehicle Emission Control Information Decal suitable for installing the Authorized Modifications Decal. Clean the area, install the decal, and cover it with a clear plastic decal shield.

OTHER APPLICABLE ARTICLES: NONE

WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage

OPERATION DESCRIPTION TIME

981306A Reprogram Powertrain 0.6 Hr.
Control Module (PCM)

DEALER CODING
CONDITION
BASIC PART NO. CODE
RECAL 42

OASIS CODES: 607000, 607400, 607700, 614500