Disc Brake System: Testing and Inspection
1. Raise vehicle on hoist.2. Remove the wheel and tire from the hub and rotor.
3. Inspect brake pads and linings for wear. If the lining is worn to within 1 mm (0.039 inch) of the pad, replace all (four) brake pads and linings (complete axle set) on front wheels as required.
4. Visually check the disc brake caliper(s). If the caliper housing is leaking, it should be replaced. If a seal is leaking, the caliper must be disassembled and new seals installed. If a piston is seized in the bore, a new caliper housing is required.
5. Lower vehicle.