Operation CHARM: Car repair manuals for everyone.

Valve Body: Service and Repair






REMOVAL
1. Disconnect battery ground cable, then raise and support vehicle.
2. Remove front fender splash shield and front splash shield to gain access to transaxle.
3. Drain transaxle fluid, then remove oil pan attaching bolts and oil pan.

Valve Body Bolt Removal:





4. Remove valve body retaining bolts, then carefully remove valve. Be careful not to loose vacuum diaphragm rod or ball and spring for converter relief valve.

INSTALLATION

Rod, Check Ball & Spring:





1. Install vacuum diaphragm rod into hole in case, then install ball and spring into slotted hole in transaxle case. Insert ball first, then spring. Use petroleum jelly to hold ball and spring in position.

Valve Body Installation:





2. Install valve body, mating manual valve groove with shift rod driving pin, then index dowel in transaxle case with mating holes in valve body holes.
3. Install valve body retaining bolts and torque to 5.9-8.1 ft lb.
4. Install oil pan and new gasket. Torque oil pan retaining bolts to 43-69 in lb. Do not use any sealer on oil pan gasket.
5. Install splash shields, then lower vehicle.
6. Add three quarts of fluid to transaxle, then start engine and check fluid level.