Selector Housing
1. Raise and support vehicle. Remove nut, stud and plastic bushing securing shift rod to selector lever.2. Lower vehicle and remove shift knob by pulling abruptly upward with the shifter in the "Neutral" position.
3. Remove PRNDL indicator attaching screws and lift off indicator.
4. Disconnect indicator illumination lamp electrical connector.
5. Remove selector housing attaching bolts and lift off housing and lever assembly.
6. Pull off rubber protective plug from housing and remove lever attaching nut. Remove lever from housing. Slide illumination lamp out of casing.
7. Reverse procedure to install. When installing the shift rod to the selector lever make sure to replace the plastic bushing.